SUPERSERVER 8048B-TRFT USER'S MANUAL Alternate ID (Available when RAID is selected in the item above-"Configure SATA as") Select Enabled for the port specified by the user to report an alternate ID to the system. The options are Enabled and Disabled. SATA Port 0/SATA Port 1/SATA Port 2/SATA Port 3/SATA Port 4/SATA Port 5 This section allows the user to configure the following settings for the SATA port specified by the user. Software Preserve Port 0/Port 1/Port 2/Port 3/Port 4/Port 5 Select Enabled to enable the port specified by the user. The options are Enabled and Disabled.
Hot Plug (Available when AHCI or RAID is selected in the item above- "Configure SATA as") Select Enabled to support Hot-plugging for the selected SATA port which will al low the user to replace a device without shutting down the system. The options are Enabled and Disabled. Port Multiplier (Available when AHCI or RAID is selected in the item above- "Configure SATA as") Select Enabled to support port-multiplier for the SATA port specified by the user. The options are Enabled and Disabled.
Spin Up Device (Available when AHCI or RAID is selected in the item above-"Configure SATA as") Select Enabled to allow the PCH to start a COMRESET initialization (from 0 to 1 on an edge detect) to the device. The options are Enabled and Disabled . SATA Device Type Use this feature to configure the SATA device type for the device installed on selected a SATA port for use of IDE mode, RAID mode or AHCI mode. The op tions are Solid State Device and Hard Disk Drive . 7-34