Supermicro 8048B-TRFT — SuperServer 8048B-TRFT User's Manual

Chapter 5: Advanced Serverboard Setup BMC Enable Jumper JPB1 allows you to enable the BMC controller on the X10QBi-A I/O module for IPMI/KVM support. The default setting is Normal. Refer to the table on the right for jumper settings. VGA Enable Jumper JPG1 allows the user to enable the onboard VGA1/2 ports on the X10QBi-A I/O module. The default setting is Enabled. See the table on the right for jumper settings. TPM Enable Jumper JPT1 allows the user to enable TPM (Trusted Platform Module) support to enhance data security. The default setting is Enabled. See the table on the right for jumper settings.

Watch Dog Enable/Disable Watch Dog (JWD1) is a system monitor that can reset the system when a software application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3 to generate a non-maskable inter­ rupt signal for the application that hangs. Refer to the table on the right for jumper settings. The default setting is Reset. Watch Dog must also be enabled in the BIOS. I 2 C Bus to PCI-Exp. Slots Use JI 2 C1 and JI 2 C2 to connect the System Management Bus (I 2 C) to the PCI-E slots to improve system performance. These two jumpers are to be set at the same time. The default setting is Open for normal operation.

Refer to the table on the right for jumper settings. 5-25 BMC Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 BMC Enabled Pins 2-3 Normal VGA Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled TPM Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset Pins 2-3 NMI Open Disabled I2C for PCI-E Slots Jumper Settings Jumper Setting Definition Closed Enabled Open Normal