S UPER S ERVER 8060 Manual Check Point Description 38 Initializing the bus input, IPL, and general devices next, if present. 39 Displaying bus initialization error messages. 3A The new cursor position has been read and saved. Displaying the Hit message next. 40 Preparing the descriptor tables next. 42 The descriptor tables are prepared. Entering protected mode for the memory test next. 43 Entered protected mode. Enabling interrupts for diagnostics mode next. 44 Interrupts enabled if the diagnostics switch is on. Initializing data to check memory wraparound at 0:0 next. 45 Data initialized. Checking for memory wraparound at 0:0 and finding the total system memory size next.
46 The memory wraparound test has completed. The memory size calculation has been completed. Writing patterns to test memory next. 47 The memory pattern has been written to extended memory. Writing patterns to the base 640 KB memory next. 48 Patterns written in base memory. Determining the amount of memory below 1 MB next. 49 The amount of memory below 1 MB has been found and verified. Determining the amount of memory above 1 MB memory next. 4B The amount of memory above 1 MB has been found and verified. Checking for a soft reset and clearing the memory below 1 MB for the soft reset next. If this is a power on situation, going to checkpoint 4Eh next. B-4