Supermicro SuperServer 8060 — Supermicro SuperServer 8060 User Manual PDF – 4U Quad Xeon Server Guide

S UPER S ERVER 8060 Manual 5-5 Installing Memory in the MEC CAUTION! Exercise extreme care when install- ing or removing DIMM modules to prevent any possible damage. The MEC must be populated in the manner described in Step 2 below. ! Memory Support: The S2QE6 supports 128MB/256MB/512MB/ and 1 GB registered ECC DIMM memory modules. 1. Removing the MEC (Memory Expansion Card): You should remove the MEC whenever installing or removing DIMMs. The MEC is attached to a retention plate with seven screws (five on the top and two on the bottom corners). Do not remove these. Instead, remove only the two screws that secure the MEC retention plate to the chassis.

After removing the board, place it on an antistatic bag before inserting the DIMMs. 2. Populating the MEC: Important: Because memory is accessed by a four-way interleav- ing scheme, you must install modules four at a time and in the order shown in Figure 5-4 and described here: If four DIMMs are to be installed, you must populate the four Bank0 slots. If eight are to be installed, you must populate the four Bank0 and the four Bank1 slots, and so on. All four DIMMs installed in a the same bank number (i.e. Bank0) must be the same brand, type, size and speed. 3. Inserting DIMMs: Insert each DIMM module vertically into its slot.

Pay attention to the two notches along the bottom of the module to prevent inserting the DIMM module incorrectly. Gently press down on the DIMM module until it snaps into place in the slot (see Figure 5-5). If you use too much pressure when inserting the DIMMs you may bend and damage the MEC. 4. Installing the MEC: After populating the MEC, carefully install it back into its slot on the motherboard, making sure it is fully seated. Finish by tightening the two screws that secure the retention plate to the chassis. 5-8