Appendix B: AMIBIOS POST Diagnostic Error Messages Appendix B AMIBIOS POST Diagnostic Error Messages This section describes the power-on self-tests (POST) port 80 codes for the AMIBIOS. Check Point Description 00 Code copying to specific areas is done. Passing control to INT 19h boot loader next. 03 NMI is Disabled. Next, checking for a soft reset or a power-on condition. 05 The BIOS stack has been built. Next, disabling cache memory. 06 Uncompressing the post code unit next. 07 Next, initializing the CPU init and the CPU data area. 08 The CMOS checksum calculation is done next. 0B Next, performing any required initialization before keyboard BAT command is issued.
0C The keyboard controller I/B is free. Next, issuing the BAT command to the keyboard controller. 0E The keyboard controller BAT command result has been verified. Next, performing any necessary initialization after the keyboard controller BAT command test. 0F The initialization after the keyboard controller BAT command test is done. The keyboard command byte is written next. B-1