SuperServer E100-9AP User's Manual 1.5 Server Installation and Setup The server is shipped with the onboard processor and the motherboard installed in the chassis. Several steps are necessary to begin using your server. You must add memory, mount the hard disk drive, and mount the system in place. Unpacking the System Inspect the box in which the system was shipped and note if it was damaged. If the server itself shows damage, file a damage claim with the carrier. Warnings and Precautions Review the electrical and general safety precautions in Appendix B. Adding Components to your System Memory :
If your system is not already fully integrated with system memory, refer to Chapter 2 for details on compatible types of memory and the installation procedure. Drives and Storage : To add storage capabilities to your server, see Chapter 2. Input/Output: See Chapter 3 for I/O ports and connect them as needed. Software : See Chapter 4 for description and procedures for installing software, including drivers and monitoring programs. 14