Supermicro SuperServer E100-9APP — Supermicro SuperServer E100-9APP User's Manual PDF (Revision 1.0a)

SuperServer E100-9APP User's Manual 7. Using a different system, extract the BIOS package into a USB flash drive. 8. Press continuously during system boot to enter the BIOS setup utility. From the top of the tool bar, click on Boot and press to enter the submenu. From the submenu list, select Boot Option #1 as shown below. Then, boot Option #1 to [UEFI AP:UEFI: Built-in EFI Shell]. Press to save the settings and exit the BIOS setup utility. 9. When the UEFI Shell prompt appears, type fs# to change the device directory path. Go to the directory that contains the BIOS package you extracted earlier from Step 7. Enter flash.nsh BIOSname.### at the prompt to start the BIOS update process. Note:

Do not interrupt this process until the BIOS flashing is complete. 10. The screen above indicates that the BIOS update process is completed. When you see the screen above, unplug the AC power cable from the power supply, clear CMOS, and plug the AC power cable in the power supply again to power on the system. 11. Press continuously to enter the BIOS setup utility. 12. Press to load the default settings. 13. After loading the default settings, press to save the settings and exit the BIOS setup utility. 94