Supermicro SuperServer E200-9AP — Supermicro SuperServer E200-9AP User's Manual (Revision 1.0) PDF Download

Chapter 2: Maintenance and Component Installation 2.4 Chassis Components Installing the Hard Drive The SC101S can accommodate a single fixed 2.5" hard drive of 15 mm thickness. It is installed to a mounting tray inside the chassis. Use an enterprise quality drive. Figure 2-4. Installing the Hard Drive Installing the Hard Drive The motherboard should be installed before installing the hard drive. 1. Make sure there is no power to the system as described in section 2.1 and remove the chassis cover. 2. Remove the two screws securing the hard drive tray to the support bracket and set them aside for later use. Lift the tray out. 3.

Place the hard drive into the tray and secure it to the tray with the screws provided with hard drive. 4. Return the hard drive tray assembly into the chassis, aligning the tabs of the tray with the slots in the chassis. Secure the tray to the chassis support bracket with the screws previously set aside. 5. Attach the cable SATA connector and to the motherboard connector. This cable carries both the SATA sginal and the SATA power. 6. Reinstall the chassis cover and power up the system. 21