SuperServer E200-9AP User's Manual LAN Port Enable/Disable Change the setting of jumpers JPL1 and JPL2 to enable or disable LAN ports 1 and 2, respectively. The default setting is Enabled. Front Panel Audio Enable JPAC1 allows you to enable or disable onboard audio support. The default setting is Enabled. SMBus to PCI Slots Jumpers JI 2 C1 and JI 2 C2 allow you to connect the System Management Bus (I 2 C) to the PCI-E/PCI slots. (JI 2 C1 controls the clock and JI 2 C2 controls the data). Both jumpers must be set to the same setting. The default setting is Enabled. Watch Dog JWD1 controls the Watch Dog function.
Watch Dog is a monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset. Note: When Watch Dog is enabled, the user must write their own application software to disable it.
32 LAN1/2 Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled Audio Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled SMB to PCI-E Slots (JI2C1/JI2C2) Jumper Settings Jumper Setting Definition Pins 1-2 Enabled (Default) Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Definition Pins 1-2 Reset (Default) Pins 2-3 NMI Open Disabled