SuperServer E200-9AP User's Manual 2. Insert the USB device that contains the new BIOS image ("Super.ROM") into your USB drive and power on the system 3. While powering on the system, keep pressing and simultaneously on your keyboard until your hear two short beeps. This may take from a few seconds to one minute. 4. After locating the new BIOS binary image, the system will enter the BIOS recovery menu as shown below. Note : At this point, decide if you want to start with BIOS Recovery. If so, continue the steps below. 5. When the screen shown above displays, use the arrow keys to select the item "Proceed with flash update" and press the key.
You will see the BIOS recovery progress as shown in the screen below. Note: Do not interrupt the BIOS flashing until it has completed. 88