Supermicro SuperServer E200-9B — Supermicro SuperServer E200-9B User & Service Manual PDF

SuperServer E200-9B User's Manual Motherboard Battery The motherboard uses non-volatile memory to retain system information when system power is removed. This memory is powered by a lithium battery residing on the motherboard. LITHIUM BATTERY BATTERY HOLDER Figure 2-3. Installing the Onboard Battery Replacing the Battery 1. Remove power from the system as described in section 3.1. 2. Push aside the small clamp that covers the edge of the battery. When the battery is released, lift it out of the holder. 3. To insert a new battery, slide one edge under the lip of the holder with the positive (+) side facing up. Then push the other side down until the clamp snaps over it. Note:

Handle used batteries carefully. Do not damage the battery in any way; a damaged battery may release hazardous materials into the environment. Do not discard a used battery in the garbage or a public landfill. Please comply with the regulations of your local hazardous waste management agency to dispose of your used battery properly. Warning: There is a danger of explosion if the onboard battery is installed upside down (which reverses its polarities). This battery must be replaced only with the same or an equivalent type recommended by the manufacturer (CR2032). 20