SuperStorageSystem 5029P-E1CTR12L User's Manual ME Manufacturing Mode Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate in the manufacturing mode, which will allow the user to flash the system firmware from a host server for system setting modifications. Refer to the table below for jumper settings. The default setting is Normal. SAS HDD Enable/Disable JPSAS1 allows you to enable the SAS HDD. See the table below for jumper settings. SAS 3.0 Enable/Disable JPS1 allows you to enable the onboard SAS 3.0 ports. See the table below for jumper settings.
54 Manufacturing Mode Jumper Settings Jumper Setting Definition Pins 1-2 Normal Pins 2-3 Manufacturing Mode SAS HDD Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled SAS Enable/Disable Jumper Settings Jumper Setting Definition Pins 1-2 Enabled Pins 2-3 Disabled