SuperStorageSystem 5029P-E1CTR12L User's Manual Aggressive Link Power Management When this item is set to Enable, the SATA AHCI controller manages the power usage of the SATA link. The controller will put the link in a low power mode during extended periods of I/O inactivity, and will return the link to an active state when I/O activity resumes. The options are Disable and Enable. *If the item "Configure SATA as" above is set to RAID, the following items will display: SATA RSTe Boot Info Select Enable to provide full int13h support for the devices attached to SATA controller The options are Disable and Enable .
SATA RAID Option ROM/UEFI Driver Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for system boot. The options are Disable, EFI, and Legacy . SATA Port 0 ~ Port 7 This item displays the information detected on the installed SATA drive on the particular SATA port. Model number of drive and capacity Software Preserve Support Port 0 ~ Port 7 Hot Plug Set this item to Enable for hot plug support, which will allow the user to replace a SATA drive without shutting down the system. The options are Disable and Enable. Port 0 ~ Port 7 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device.
The options are Disable and Enable. Port 0 ~ Port 7 SATA Device Type Use this item to specify if the SATA port specified by the user should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. PCH sSATA Configuration When this submenu is selected, the AMI BIOS automatically detects the presence of the SATA devices that are supported by the Intel PCH chip and displays the following items: sSATA Controller This item enables or disables the onboard sSATA controller supported by the Intel PCH chip. The options are Enable and Disable. 78