SuperStorageSystem 5049P-E1CTR36L User's Manual Chapter 3 Maintenance and Component Installation This chapter provides instructions on installing and replacing main system components. To prevent compatibility issues, only use components that match the specifications and/or part numbers given. Installation or replacement of most components require that power first be removed from the system. Please follow the procedures given in each section. 3.1 Removing Power Use the following procedure to ensure that power has been removed from the system. This step is necessary when removing or installing non hot-swap components or when replacing a non-redundant power supply. 1.
Use the operating system to power down the system. 2. After the system has completely shut-down, disconnect the AC power cord(s) from the power strip or outlet. (If your system has more than one power supply, remove the AC power cords from all power supply modules.) 3. Disconnect the power cord(s) from the power supply module(s). 3.2 Accessing the System The SC847BE1C-R1K23LPB features a removable top cover, which allows easy access to the inside of the chassis. Removing the Top Cover 1. Remove power from the system as described in Section 3.1. 2. Remove the screws securing the cover to the chassis. 3. Lift the cover up and off the chassis. Warning :
Except for short periods of time, do not operate the server without the cover in place. The chassis cover must be in place to allow for proper airflow and to prevent overheating. 25