Chapter 3: Maintenance and Component Installation Assembling the Processor Heatsink Module (PHM) After creating the processor package assembly, mount it onto the heatsink to create the processor heatsink module (PHM). 1. Locate "1" on the heatsink label and the corner next to it. With your index finger pressing against the screw at this corner, carefully turn the heatsink upside down with the thermal grease side facing up. 2. Remove the protective thermal film if present. If this is a new heatsink, the necessary thermal grease has been pre-applied in the factory. If the heatsink is not new, apply the proper amount of thermal grease. 3.
Holding the processor package assembly by the edge, locate the hollow triangle at the corner ("a" in the drawing below), and note a hole and plastic mounting clips next to the triangle. Also locate another set of mounting clips and a hole at the diagonal corner of the of the processor package assembly ("b" in the drawing). 4. With the under side of heatsink and Non-Fabric CPU and Processor Clip (Upside Down) the under side of the processor package assembly facing up, align the corner on the heatsink ("A" in the drawing) against the mounting clips next to the hollow triangle ("a") on the processor package assembly. b Triangle on the CPU d c B a 5.
Also align the corner ("B") at the C D diagonal side of the heatsink with the corresponding clips on the processor package assembly ("b"). Triangle on the Processor Clip A Heatsink (Upside Down) 6. Once aligned, press the processor package assembly onto the heatsink until the mounting clips (at a, b, c, and d) snap into place. On Locations of (C, D), the notches snap onto the heat sink’s mounting holes B D C The processor heatsink module (PHM) is created. A On Locations (A, B), the notches snap onto the heatsink’s sides Make sure Mounting Notches snap into place Processor Heatsink Module for the Processors 32