Supermicro 5049P-E1CTR36L — Supermicro SuperStorage 5049P-E1CTR36L User's Manual PDF

SuperStorageSystem 5049P-E1CTR36L User's Manual Chapter 5 Software After the hardware has been installed, you should install the Operating System (OS), configure RAID settings and install the drivers. Necessary drivers and utilities may be found at ftp://ftp. supermicro.com/driver . 5.1 OS Installation You must first configure RAID settings (if using RAID) before you install the Windows OS and the software drivers. To configure RAID settings, please refer to the RAID Configuration User Guides posted on our website at www.supermicro.com/support/manuals . Installing the Windows OS for a RAID System 1.

Insert Microsoft's Windows Setup DVD in the DVD drive and the system will start booting up from the DVD. 2. Insert the USB stick containing Windows drivers to a USB port on the system. Note: for older legacy OS's, please use a method to slipstream the drivers. 3. Select the partition on the drive in which to install Windows. 4. Browse the USB folder for the proper driver files. 5. Choose the RAID driver indicated in the Windows OS Setup screen, then choose the hard drive in which you want to install it. 6. Once all devices are specified, continue with the installation. 7. After the Windows OS installation is completed, the system will automatically reboot.

Installing Windows to a Non-RAID System 1. Insert Microsoft's Windows OS Setup DVD in the DVD-ROM drive and the system will start booting up from the DVD. 2. Continue with the installation. The Windows OS Setup screen will display. 3. From the Windows OS Setup screen, press the key. The OS Setup will automatically load all device files and then continue with the Windows installation. 4. After the installation has completed, the system will automatically reboot. 60