Supermicro 5049P-E1CTR36L — Supermicro SuperStorage 5049P-E1CTR36L User's Manual PDF

SuperStorageSystem 5049P-E1CTR36L User's Manual Configure sSATA as Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID to configure an sSATA drive specified by the user as a RAID drive. The options are AHCI and RAID. SATA HDD Unlock This feature allows the user to remove any password-protected SATA disk drives. The options are Disable and Enable . Aggressive Link Power Management When this item is set to Enable, the SATA AHCI controller manages the power usage of the SATA link. The controller will put the link in a low power mode during extended periods of I/O inactivity, and will return the link to an active state when I/O activity resumes.

The options are Disable and Enable. *If the item above "Configure sSATA as" is set to RAID, the following items will display: sSATA RSTe Boot Info Select Enable to provide full int13h support for the devices attached to sSATA controller. The options are Disable and Enable . sSATA RAID Option ROM/UEFI Driver Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for system boot. The options are Disable, EFI, and Legacy . sSATA Port 0 ~ Port 2 This item displays the information detected on the installed sSATA drive on the particular sSATA port.

Model number of drive and capacity Software Preserve Support Port 0 ~ Port 2 Hot Plug Set this item to Enable for hot plug support, which will allow the user to replace a SATA drive without shutting down the system. The options are Disable and Enable. Port 0 ~ Port 2 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The options are Disable and Enable. Port 0 ~ Port 2 sSATA Device Type Use this item to specify if the SATA port specified by the user should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. 82