Supermicro SuperWorkstation 5037A-I — Supermicro SuperWorkstation 5037A-I User Manual PDF Download

Chapter 5: Advanced Serverboard Setup Power Button The connection for the power button is on pins 1 and 2 of JF1. The chas­ sis power button should be connected here. See the table on the right for pin definitions. Reset Connector The reset header is located on pins 3 and 4 of JF1. Attach the reset switch on the computer chassis to these pins. See the table on the right for pin definitions. Overheat/Fan Fail LED (JOH1 ) The JOH1 header is used to connect an LED to provide warnings of chassis over­ heat. This LED will also blink to indicate a fan failure. Refer to the table on right for pin definitions.

NIC1/NIC2 (LAN1/LAN2) The NIC (Network Interface Controller) LED connection for LAN port 1 is located on pins 11 and 12 of JF1, and the LED connection for LAN Port 2 is on Pins 9 and 10. NIC1 LED and NIC2 LED are 2-pin NIC LED headers. Attach NIC LED cables to NIC1 and NIC2 LED indicators to display network activities. Refer to the table on the right for pin definitions. HDD LED The HDD LED connection is located on pins 13 and 14 of JF1. Attach a cable here to indicate the status of HDD-related activi­ ties, including IDE, SATA activities. See the table on the right for pin definitions.

5-17 Power Button Pin Definitions (JF1) Pin# Definition 1 PW ON _ 2 Ground Reset Button Pin Definitions (JF1) Pin# Definition 3 Reset 4 Ground Overheat LED Pin Definitions Pin# Definition 1 5vDC 2 OH Active OH/Fan Fail LED Pin Definitions State Message Solid Overheat Blinking Fan Fail LAN1/LAN2 LED Pin Definitions (JF1) Pin# Definition 9/11 LED VCC 10/12 Ground HDD LED Pin Definitions (JF1) Pin# Definition 13 LED VCC 14 HD Active