Appendix C: Intel HostRAID Setup Guidelines Appendix C Intel HostRAID Setup Guidelines After all the hardware has been installed, you must fi rst confi gure the Intel ESB2 SATA RAID before you install the Windows Operating System and other software drivers. Important Notes If you do not wish to confi gure onboard SATA RAID functions, please go directly to Section C-2, Appendix D and Appendix E for Operating System & Other Software Installation. This chapter describes RAID Confi guration Instructions for the Intel ESB2 RAID Controller designed for the Windows OS.
C-1 Introduction to Serial ATA and Parallel ATA To confi gure the SATA RAID functions, you must fi rst use the Intel ESB2 SATA RAID Utility program to confi gure the RAID Level that you desire before installing the Windows XP/2003 operating system and other software drivers. (The necessary drivers are all included on the Supermicro CD that came packaged with your motherboard.) Note : the current version of the ESB2 SATA RAID Utility can only support Windows XP/2003 Operating Systems. Serial ATA (SATA) Serial ATA (SATA) is a physical storage interface that uses a single cable with a minimum of four wires to create a point-to-point connection between devices.
It is a serial link, which supports transfer rates up to 3.0 Gbps. Because the serial cables used in SATA are thinner than the traditional cables used in Parallel ATA (PATA), SATA systems have better airfl ow and can be installed in smaller chassis. In addition, the cables used in PATA are limited to a length of 40cm, while Se- rial ATA cables can be up to one meter in length. Overall, SATA provides better functionality than PATA. Introduction to the Intel ESB2 Serial RAID Located in the South Bridge of the 5400 chipset, the I/O Controller Hub (ESB2) provides the I/O subsystem with access to the rest of the system.
It supports 1- channel UltraATA/100 Bus Master IDE controller (PATA) and six Serial ATA (SATA) ports. The ESB2 supports the following PATA and SATA device confi gurations: Legacy mode and Native mode. C-1