Appendix D: Adaptec HostRAID Setup Guidelines Appendix D Adaptec HostRAID Setup Guidelines After all the hardware has been installed, you must fi rst confi gure the RAID before you install the Windows operating system. The necessary drivers are all included on the Supermicro bootable CDs that came packaged with your motherboard. Note : The following section provides information on the Adaptec SATA RAID Driver based on the Intel Enterprise South Bridge 2 (ESB2) Controller. D-1 Introduction to the Adaptec SATA RAID Controller Serial ATA (SATA) Serial ATA(SATA) is a physical storage interface.
It uses a single cable with a minimum of four wires to create a point-to-point connection between devices. It is a serial link which supports SATA Transfer rates up to 3.0 Gbps. Because the serial cables used in SATA are thinner than the traditional cables used in Paral- lel ATA (PATA), SATA systems have better airfl ow and can be installed in smaller chassis than PATA. In addition, the cables used in PATA can only extend to 40cm long, while SATA cables can extend up to one meter. Overall, SATA provides better functionality than PATA.
Introduction to the Intel ESB2 I/O Controller Hub Located in the South Bridge of the Intel 5400 Chipset, the ESB2 I/O Controller Hub provides the I/O subsystem with access to the rest of the system. It supports 1-channel Ultra ATA/100 Bus Master IDE controller (PATA) and one Adaptec SATA Host Controller, which support up to six Serial ATA drives, up to two RAID volumes and up to four drives in RAID confi gurations. See the table below for details. D-1 * Adaptec’s SATA HostRAID Controller Firmware supports: Drives supported Six Number of RAID Volumes supported Two Total Drives in RAID Configurations Four Examples of Valid RAID Configurations:
Two drives of RAID 1 + two drives of RAID 0 Two drives of RAID 1 + two drives of RAID 1 Three drives of RAID 0 Four drives of RAID 0 Examples of Invalid RAID Configurations: Three drives of RAID 0 + two drives of RAID 1 (*Note: this table is applicable to Adaptec’s HostRAID Controller Firmware only.)