Chapter 3: System Interface the system or the ambient room temperature being too warm. Check the routing of the cables and make sure all fans are present and operating normally. You should also check to make sure that the chassis covers are installed. Finally, verify that the heatsinks are installed properly (see Chapter 5). This LED will remain fl ashing or on as long as the indicated condition exists. 3-4 Drive Carrier LEDs SATA Drives Green: Each Serial ATA drive carrier has a green LED. When illuminated, this green LED (on the front of the SATA drive carrier) indicates drive activity.
A connection to the SATA backplane enables this LED to blink on and off when that particular drive is being accessed. Please refer to Chapter 6 for instructions on replacing failed SATA drives. Red: The red LED to indicate an SATA drive failure. If one of the SATA drives fail, you should be notifi ed by your system management software. Please refer to Chapter 6 for instructions on replacing failed SATA drives. 3-3