Super Micro Computer, Inc. 7045A-WT — Super Micro 7045A-WT User Manual: Comprehensive Guide for System Integrators and Technicians

Chapter 5: Advanced Serverboard Setup 5-6 Installing Memory CAUTION! Exercise extreme care when installing or removing DIMM modules to prevent any possible damage. ! Installing Memory Modules Insert the desired number of DIMMs into the memory slots, starting with Bank 1. 1. Refer to the Memory Confi guration Table below for more details. Insert each DIMM vertically into its slot. Pay attention to the notch along the 2. bottom of the module to prevent inserting the DIMM incorrectly. Gently press down on the DIMM module until it snaps into place in the slot. 3. Repeat for all modules (see step 1 above). Memory Support The X7DWA-N supports up to 64 GB of FBD ECC DDR2-800/667/533 in 8 slots.

Populating slots with a pair (or pairs) of DIMMs of the same type and size will result in interleaved memory. For best performance, please install pair(s) of DIMM modules of the same type in both Branch 0 and Branch 1. Note : Different types of memory modules are supported by processors with different front side bus speeds. Refer to the Memory Support Table below. *DDR2 FBD 800 MHz memory is supported by 1333 MHz and 1066 MHz FSB processors, but will run at 667 MHz.

5-9 Memory Configuration Table Branch0 Branch1 Number of DIMMs Bank 1 (Channel 0) Bank 2 (Channel 1) Bank 3 (Channel 2) Bank 4 (Channel 3) 2 DIMMs 1A ------ 2A ------ ------ ------ ------ ------ 4 DIMMs 1A ------ 2A ------ 3A ------ 4A ------ 6 DIMMs 1A 1B 2A 2B 3A ------ 4A ------ 8 DIMMs 1A 1B 2A 2B 3A 3B 4A 4B Notes: i. DIMM slot# specified = DIMM slot to be populated; “---“ = DIMM slot not to be populated. ii. FBD 533 MHz, 667MHz and 800 MHz DIMMs are supported, however we recommend that you use memory modules of the same speed and type. Memory Support Table CPU DIMM FSB: 1600 MHz FSB: 1333 MHz FSB:

1066 MHz 800 MHz Supported Supported* Supported* 667 MHz Supported Supported Supported 533 MHz Not Supported Supported Supported