Super Micro Computer, Inc. 7045A-WT — Super Micro 7045A-WT User Manual: Comprehensive Guide for System Integrators and Technicians

Chapter 5: Advanced Serverboard Setup IDE Connectors There are two IDE connectors (one blue and one white) on the serverboard. IDE1 (blue) is desig- nated as the Primary IDE drive. The white connector is designated as the Secondary IDE drive and is reserved for Compact Flash Card use only. (See the note below.) See the table on the right for pin defi nitions. Note : The white slot is reserved for Compact Flash Cards only. Do not use it for other devices. If populated with a Compact Flash Card, IDE1 (the blue slot) will be available for one device only. For the Compact Flash Card to work properly, you will need to connect a power cable to JWF1 fi rst.

SATA Ports There are no jumpers to confi gure the onboard SATA connectors. See the table on the right for pin defi ni- tions.

5-27 IDE Drive Connector Pin Defi nitions (IDE1) Pin# Defi nition Pin # Defi nition 1 Reset IDE 2 Ground 3 Host Data 7 4 Host Data 8 5 Host Data 6 6 Host Data 9 7 Host Data 5 8 Host Data 10 9 Host Data 4 10 Host Data 11 11 Host Data 3 12 Host Data 12 13 Host Data 2 14 Host Data 13 15 Host Data 1 16 Host Data 14 17 Host Data 0 18 Host Data 15 19 Ground 20 Key 21 DRQ3 22 Ground 23 I/O Write 24 Ground 25 I/O Read 26 Ground 27 IOCHRDY 28 BALE 29 DACK3 30 Ground 31 IRQ14 32 IOCS16 33 Addr1 34 Ground 35 Addr0 36 Addr2 37 Chip Select 0 38 Chip Select 1 39 Activity 40 Ground SATA Port Pin Defi nitions (I-SATA0~I-SATA5) Pin # Defi nition 1 Ground 2 TXP 3 TXN 4 Ground 5 RXN 6 RXP 7 Ground