Supermicro SuperWorkstation 7047GR-TRF — Supermicro SuperWorkstation 7047GR-TRF User's Manual PDF

Chapter 5: Advanced Serverboard Setup VGA Enable/Disable JPG1 allows you to enable or disable the VGA port. The default position is on pins 1 and 2 to enable VGA. See the table on the right for jumper settings. Watch Dog Enable/Disable JWD controls the Watch Dog function. Watch Dog is a system monitor that can reboot the system when a software application hangs. Jumping pins 1-2 will cause WD to reset the system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the application that hangs. See the table on the right for jumper settings. Watch Dog must also be enabled in BIOS.

BMC Enable Jumper JPB1 allows you to enable the embedded Nutovon (Baseboard Management) Controller to provide IPMI 2.0/KVM support on the serverboard. See the table on the right for jumper settings. '97 Audio Enable Close Pins 1~2 of Jumper JPAC1 to enable '97 Audio support. See the table on the right for jumper settings. The default setting is enabled. High Defi nition (HD) Audio Enable Jumper JHD_AC1 allows the user to enable High Defi nition Audio support. Close Pins 1~2 of JHD_AC1 to use HD audio. See the table on the right for jumper settings. The default setting is enabled.

5-23 VGA Enable/Disable Jumper Settings Jumper Setting Defi nition Pins 1-2 Enabled Pins 2-3 Disabled Watch Dog Jumper Settings Jumper Setting Defi nition Pins 1-2 Reset Pins 2-3 NMI Open Disabled BMC Enable Jumper Settings Jumper Setting Defi nition Pins 1-2 BMC Enable Pins 2-3 Normal (Default) '97 Audio Enable Jumper Settings Jumper Setting Defi nition 1-2 Enabled 2-3 Disabled HD Audio Enable Jumper Settings Jumper Setting Defi nition 1-2 Enabled 2-3 Disabled