Supermicro SuperWorkstation 7048GR-TR — Supermicro SuperWorkstation 7048GR-TR User's Manual (Rev 1.0c) PDF Download

SUPERWORKSTATION 7048GR-TR User’s Manual Model number of drive and capacity Software Preserve Support Port 0~ Port 5 Select Enabled to enable a SATA port specified by the user. The options are Disabled and Enabled . Port 0 ~ Port 5 Hot Plug Select Enabled to enable hot-plugging support for a port specified by the user, which will allow the user to replace a SATA disk drive installed on this port without shutting down the system. The options are Enabled and Disabled . Port 0 ~ Port 5 Spin Up Device On an edge detect from 0 to 1, set this item to allow the PCH to start a COMRE­ SET initialization to the device. The options are Enabled and Disabled .

Port 0 ~ Port 5 SATA Device Type Use this item to specify if the SATA port specified by the user should be con­ nected to a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive. sSATA Configuration When this submenu is selected, AMI BIOS automatically detects the presence of the SATA devices that are supported by the PCH-sSATA controller and displays the following items: sSATA Controller This item enables or disables the onboard SATA controller supported by the Intel PCH-sSATA controller. The options are Enabled and Disabled. Configure sSATA as Select IDE to configure an sSATA drive specified by the user as an IDE drive.

Select AHCI to configure an sSATA drive specified by the user as an AHCI drive. Select RAID to configure an sSATA drive specified by the user as a RAID drive. The op­ tions are IDE, AHCI , and RAID. *If the item above "Configure sSATA as" is set to AHCI, the following items will display: 7-18