Supermicro SuperWorkstation 7048GR-TR — Supermicro SuperWorkstation 7048GR-TR User's Manual (Rev 1.0c) PDF Download

Appendix A: BIOS Error Beep Codes Appendix A BIOS Error Beep Codes During the POST (Power-On Self-Test) routines, which are performed at each system boot, errors may occur. Non-fatal errors are those which, in most cases, allow the system to continue to boot. The error messages normally appear on the screen. Fatal errors will not allow the system to continue with the bootup procedure. If a fatal error occurs, you should consult with your system manufacturer for possible repairs. These fatal errors are usually communicated through a series of audible beeps. The numbers on the fatal error list correspond to the number of beeps for the corresponding error.

A-1 X10 Serverboard BIOS Error Beep Codes Beep Code/LED Error Message Description 1 beep Refresh Ready to boot 5 short beeps + 1 long beep Memory error No memory detected in the system 5 beeps No Con-In or No Con- Out devices Con-In includes USB or PS/2 key­ board, PCI or Serial Console Redirec­ tion, IPMI KVM or SOL. Con-Out includes Video Controller, PCI or Serial Console Redirection, IPMI SOL. 1 beep per device Refresh 1 beep or each USB device detected X10 IPMI Error Codes 1 Continuous Beep System OH System Overheat