Chapter 6: Advanced Chassis Setup When using passive GPUs, you must use the GPU cooling kit, MCP-320-74701-0N- KIT. This kit consists of two fans with brackets that can be attached to the back of the chassis and one mylar air shroud to concentrate air flow to the GPUs. Installing the GPU Kit Installing External Rear Fans 1. Power down the system, disconnect the power cords from the rear of the power supplies and open the chassis cover. 2. Insert the feet on the bottom of the external rear fan into the corresponding slots on the bottom of the fan bracket. 3. Push the top of the fan into the bracket until it clicks into the locked position.
1 6 Align with Mounting Holes and Place Screw Here 1 6 Run Fan Wiring Here Align with Mounting Holes and Place Screw 1 5 Here Place Bracket Mounting Pins Here 1 3 Insert Fan Feet into Mounting Holes Here 1 2 Figure 6-15. External Rear Fan Bracket Mounting Pin Placement 6-13