Preparation before use EN 5 Preparation before use 5.1 Connect the power supply The oscilloscope is equipped with 4 3.7V 2600 mAh batteries. Press the power button, the buzzer rings, and the instrument starts up. Press the power button again, the instrument shuts down. Before starting, please make sure the batteries have enough power. When the battery box on the screen is blank, it indicates that the battery is about to run out. When the battery level is lower than 3.5V, the oscilloscope will prompt "shut down after 30s". Tap the screen to cancel the popup box. "Shutdown after 20 seconds" and "shutdown after 10 seconds" will appear subsequently.
To avoid automatic shutdown due to insufficient power supply, please charge in time. If the power button is pressed and the buzzer rings continuously but the oscilloscope doesn ’ t respond, it may indicate that the battery power may be exhausted. Please charge in time. You can charge the oscilloscope in the following ways: Charge the oscilloscope through the power adapter: connect the oscilloscope to the power socket through the USB data cable and the power adapter in accessories for charging. When charging, if the machine is not started, the indicator light of the power button will be on; If the machine is turned on, the battery box on the screen will change (slow charge , quick charge ).
When the battery is full, the oscilloscope will stop charging automatically. 5.2 Boot check Press the power button at the bottom of the right panel to start the instrument. Shutdown: ⚫ Tap the shutdown icon at the top of the main interface to shut down directly. ⚫ In the boot state, press the power button to shut down directly. 5.3 Set the system language This oscilloscope supports Chinese and English. Click [HOME] to enter the main interface and click [Settings] > Language to select the language. Copyright © Qingdao Hantek Electronics Co., LTD Tablet1000 Quick guide 13