From version 2.x.xxxx.x | Samples Comment The block does not synchronize the Simulink ® simulation with the TwinCAT runtime, but with the local system time. Synchronization of the local system time is done by "braking" the Simulink ® simulation; acceleration is not possible. For a fully synchronized software-in-the-loop simulation between TwinCAT and Simulink ® you need a TwinCAT 3 Usermode Runtime: External Control and the SiL Connector Block in Simulink ® . 3.7 Samples | Samples The MATLAB ® Command Window provides you with a list of provided samples. To do this, use the command: TwinCAT.ADS.Samples.List TE1410 42 Version:
1.3.1 Sync Clock Mode None Simulation is neither accelerated nor decelerated. Clock Simulation time and system time are synchronized. ClockWithTime Simulation time and system time are synchronized. In addition, an output port is created that displays the past system time. ClockWithTimeAndDeviation Simulation time and system time are synchronized. In addition, an output port is created that shows the past system time and the deviation between simulation time and system time.