E165GB — Technische Informationen

SOFTWARE SOFTWARE 9.4.15. Copying a program 9.4.16. Program transfer g, the as possible and easy in t mm ra as efficien making prog the inteofrest KUAX 671 oa kuax 671 cam controller, in conjunction with the she one num| terminal, gives you the capability to copy a program from ‘ine operation of the another. This is a considerable advantage when the one Progra 10 As desc above, ribe the KUAXd671 PG hand term isinal fitted with a Program memory which is buffered with its own rechargeable battery. program memory is accessed with program number 8.

A program whichThisis will require several programs with only minor changes from can be made simply then copied into the terminal willbe maintained even after the connector cable is detached. the next. After copying the entire program the changes To make the program transfer to another cam controller you need only attach the concable nec and call tor up the copy function. This technique makes it possible to transfer a program, once it has been written, to any desired number of cam controllers. Important: The outputs are disabled during the transfer procedure. ats designate as the destination. Entry Example for copying a program:

‘COPY i | OOW program memory; itis ‘The hand terminalis also equipped with a buffered use when assigned program number 8. This was originally intended for transferring a program from one cam controllerto another, but can also be used as a back-up for one program. Display Comments Copy from — to be copied. of the program ‘The aa number of the program to be Copy from 0. Example for program transfer: Copy from 0 08 09057 No=F from Yes=ENTER 0, Posse AMS Comments ‘Copy from _ The machine asks here for the ‘number of the program to be copied.

“The machine asks for the number 4 Copy froea 0 ENTER ‘Copy from 0 to PS ‘The machine asks for the number Copy from 0 Display from 0 under which the program is to be copied (destination). program (The buffered memory is entered. is activated in the hand terminal by entering program number 8). IMPORTANT! question; This anesracreomm Dacais a verification stored under program number 5, the program from 0 will be wrtten over the existing program. rdwill format nda “The stadisplay period of a brief ar after pe reap routinegis time. The copyin ENTER [pm] from 0 to 8? YessENTER No=F ‘The number of the program to be has been Here the machine asks for the new program number (destination).

‘The destination number has been Dette ie the hand terminalis activated by rogram number 8. IMPORTANT! This is a verification question, since a program which has already ‘been copied at program 8 in the terminal will be written over during the copy procedure. ENTER [pa] ENTER [r=] controller STOP The outputs Abort P are disabled. YessENTER No=F the routine by pressing "F". ese = ‘The standard display format will aftr the transfer of reappear the 32 ‘The program is now in storage of the hand terminal. If you wish to transfer this program to a secound cam controller you must first attach the connector cable and then enter the numerical key code giving access to the programming mode.

The copy function can now be called up. The operating sequence is as described above; the transfer, however is made from program number 8 (in the hand terminal) to the cam controller. complete. {If you copy into the memoryin the hand terminal, the blocks ‘which are copied will be shown in the display. copy from 8 ton 45 46