HARDWARE HARDWARE 4. Hardware of the KUAX 671 4.3. Illustration of the control unit 4,1, General in a 671 is mounted The control electronics of the cam control unit KUAX applicati The ons. industrial for suitable robust, finished metal housing angle or, if desired, using housing can be installed either with a mounting couplers for mounting rails complying with DIN 46277. 4.2 Mechanical design The electronics comprise two modules: e _- integrated power pack 1. The CPU modulwith - programming interface 2.
Inpuvfoutput module with - connector plug (D-Sub) for the encoder ~ terminal strip for connecting the external program selection device - connection terminals for the outputs - integrated output LEDs (optional) ‘A terminal block is used as the attachment point to supply power both to the and to the intemal power pack for the cam controller (24 V DC, I There is anerror in the program speed (with dynamic version only) 7 Hook switch to reverse the direction of encoder rotation 8 Output LEDs. 9 Battery compartment for Lithium battery. —+ _ a —> ‘Terminal block for the extemal program selection. 25pole D plug for the absolute angle encoder. 6 Plug connector for the hand terminal. w Display:
w nt amou of current. 24 V DC input for the built-in power supply to the cam controller and to the outputs. Encoder has reached maximum SHORT (KS) —* __ —+» Short circuit indicator Flat battery (depending on type) Report outputs —® Short circuits and parity,battery check. (Order No.: 671.022.16 or 32) after unscrewing the side panel). (accessible only