Trouble shooting guide EN Tip, especially for meat: the cooking results on the preset programmes may vary depending on origin, cut and quality of the food being cooked, the programmes have been set and tested for good quality food. Similarly, the thickness of the meat has to be taken into account during cooking; you may not cook food that is thicker than 4 cm. 54 roblem Cause Solution he appliance switches to manual mode when starting a cooking ycle. • Starting a cooking cycle without preheating. • 2 possible options:
- a llow to cook, but you must monitor the cooking (white LED = manual mode) - stop the appliance, remove the food, close the appliance properly, reprogram the appliance and wait until end of preheating. he appliance switches to manual mode when starting a cooking cycle. • Appliance failure. • Contact your local Tefal Customer Service. he appliance stops during he pre-heating or cooking cycle. • The appliance has been kept open for too long while preheating or cooking. • The appliance has been idle too long after the end of warm up or keep warm. • Disconnect the appliance from the mains leave for 2-3 mins, restart the process.
The next time you use the appliance, make sure you open and close it briefly for best cooking results. If the problem continues, contact your local Tefal Customer Service. ndicator flashing after placing he food on the cooking plates. • Not sensing the food. Meat thickness too thin. • You must confirm the start of the cooking by pressing the button . Flashing white indicator light. button flashing r button flashing • Appliance failure. • Appliance stored or used in a room that is too cold. • Disconnect and reconnect your appliance and immediately restart a preheat cycle. If the problem persists, contact your Customer Service. he appliance no longer beeps.
have put in my food and closed he appliance but cooking has not tarted. • Your food has a depth thicker than 4 cm. • Your food is under 4 mm thick. • You have not waited for the appliance to pre-heat. • Food must not be thicker than 4cm. • You must confirm the start of the cooking by pressing the button OK. • Wait for the audible beep and the cooking level indicator to flash purple before adding food. have put in my food but the ndicator stays on PURPLE . • You have not completely opened the grill when putting on the food. • Completely open the grill then close it. • Not sensing the food. Meat thickness too thin.
Minimum thickness = 4mm • Confirm the start of the cooking by pressing the button . he appliance turns itself off uring cooking in manual mode. • The cooking time has exceeded 30 minutes. • Press the on/off button and re-start the manual mode.