Auto-Stop safety feature (depending on the model) - The electronic system cuts off the electric power and the Auto-Stop warning light flashes if the iron is left vertically on its heel for more than 8 minutes, or in a horizontal position for more than 30 seconds. - To restart the iron, just move it gently until the warning light stops flashing. Note:When the Auto-Stop warning light is on, it is normal for the thermostat light to be off. M 2- DRY IRONING - Set the steam control on DRY (see diagram A). - Set the temperature. - You may start ironing when the thermostat light goes out and comes on again. 3- MAINTAINING YOUR IRON BE CAREFUL !
Unplug your iron and let it cool off before cleaning it. CLEANING THE ANTI-CALC VALVE (Once per month) : - Unplug your iron and empty the water tank. - To remove the anti-calc valve, pull it up using the tabs located on each side (N). NEVER TOUCH THE END OF THE VALVE. - Soak the rod in a cup of white spirit vinegar or plain lemon juice for 4 hours (O). - Rinse the valve in tap water. - Place the steam control on dry. - Replace the anti-scale valve. THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE N O USING THE SELF-CLEANING FUNCTION In order to extend the life of your iron, use the Self-Cleaning function once per month. - Unplug your iron and set the steam control on DRY .
- Fill the water tank up to the limit (see recommendations for the types of water to use). - Leave water tank filler cover open until the end of the operation - Place your iron on its heel and set the thermostat control on MAX. - Plug in your iron and wait until the thermostat light goes out. - Unplug the iron and hold it over a sink in the horizontal position. - Place the steam control on MAX. 4