28 en 15. Push the milk frother (6) in to close it. The appliance heats up and rinses. Some water will run out of the coffee outlet. When the drink selection menu is shown in the display, the appliance is ready for use. Water filter A water filter can prevent scale buildup. Before a new water filter is used, it must be rinsed. To do this, proceed as follows: 1. Press the water filter firmly into the water tank with the aid of the measuring spoon (18). 2. Fill the water tank (16) with water up to the max mark. 3. Press and hold the e off / j button (12) for at least three seconds. The menu opens. 4.
Press the e off / j button (12) Switching off the appliance If the appliance has not been used for an hour, it rinses automatically and then switches off (time span can be programmed, see “Menu settings” Shut off on page 29). Exception: The appliance switches off without rinsing if only hot water or steam were dispensed. repeatedly until the display shows No / Old filter . 5. Select Activate filter with the upper rotary knob (14). 6. Press the start button (10). 7. Place a receptacle with a capacity of 0.5 litres under the outlet. 8. Press the start button (10). 9. Pull the milk frother (6) to open it. 10. Water will now flow through the filter to rinse it. 11.
Push the milk frother (6) in to close it. 12. Empty the container. The appliance is ready to use once more. To switch the appliance off manually before this, press the e off / j button (12). The appliance rinses and switches off. N.B.: If the appliance is being used for the first time, a service program has been run, or the appliance has not been operated for a long period, the first beverage will not have the full aroma and should not be consumed. When using the espresso machine for the first time, you will achieve a suitably thick and stable “crema” only after the first few cups have been dispensed. Note: Rinsing the filter simultaneously acti- vates the setting for the Change filter!
display. After extended use, water droplets may form on the ventilation slots. This is normal. The filter is no longer effective when the Change filter! display appears, or at the latest after 2 months. It needs to be replaced for reasons of hygiene and so that there is no build-up of limescale (this could damage the appliance). Replacement filters can be obtained from retailers (TCZ7003) or from customer service (575491). If no new filter is used, turn the filter setting to No / Old . Robert Bosch Hausgerдte GmbH TES55236RU.indb 28 04.06.2013 14:35:44