Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 METHOD 2206 LINEAR AMPLIFIER POWER OUTPUT AND DISTORTION, WHITE NOISE METHOD (Single-Sideband) 1. Purpose. To determine the intermodulation (IM) distortion and power output (normally up to 32 MHz) with a white, Gaussian noise signal, that simulates multitone modulation in grounded-cathode linear amplifier service. 1.1 General. A white noise signal of Gaussian amplitude distribution having an insertable narrow notch, located near the center of the channel passband, is applied to the TUT. The level of the applied notched noise signal is set to drive the TUT to the minimum power output level specified on the individual TSS.
The noise power output shall be measured in the notch filter bandwidth for both the notch-in and the notch-out conditions. The relative power may be established by switching the notch-out and readjusting the signal for the minimum power output level specified on the individual TSS. Other means that provide an accurate measure of the signal noise power (notch filter out) to IM noise power (notch-in) can be used if equivalent accuracy is shown. The test signal at the TUT shall meet the requirements shown on figure 2206-1 for the notch-in case and the following: a. Noise spectrum.
The noise generator output shall be flat (constant power per hertz of bandwidth) 1 dB over 100 Hz to 12,000 Hz passband of the test signal. b. Noise amplitude distribution. The noise signal amplitude density distribution shall be as indicated below when measured in a narrow window (for example, 0.2 (sigma) where sigma is the standard deviation or rms value of the noise voltage). Voltage (in sigma) Amplitude density distribution 0 1 2 3 0.0796 0.005 0.0484 0.005 0.0108 0.003 0.000898 0.0002 c. The notch-out case is just removal of slot from figure 2206-1. The TUT circuit shall be in general accordance with the provisions of figure 2206-2 and figure 2206-3. d.
Signal to IM distortion ratio (S/IMD) is defined as: The ratio of the test signal noise power to that of the IM distortion noise power in the notch, expressed in dB. It should be noted that this number (in dB) may not be identical with that number provided by the NPR-(SSB) test of MIL-STD-188. Noise from causes other than noise intermodulation distortion products also contributes to the spectral content within the cleared portion of a notched noise signal in single sideband or independent sideband equipment output. e. The noise test signal may be initiated at an rf level or an audio level.
If an audio noise generator and filters are used, the dynamic range of the frequency translator shall be wide (90 dB) and the phase noise associated with the conversion injection signal shall be sufficiently small so as to not affect the S/IMD measurement. 2. The following shall be specified on the TSS: a. DC voltages applied to the tube elements. b. The drive source impedance (Zs) shall be resistive and 1,000 ohms maximum. c. Load resistance (R ) with tolerance. d. Anode tank loaded Q, with tolerance. e. Idling anode current (Ibo) with no rf drive applied. METHOD 2206 19 April 1968 2206-1