Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 3.2 Procedure. With the TUT inserted in the circuit shown on figure 4263-2, a signal of specified power and frequency of F1 is fed to the TUT input. The power output at F1 is measured. A signal of specified power and frequency of F2 is then added to the input of the TUT, and the output power at frequency F1 is again measured. The change in output power Po at frequency F1 is then calculated. The filter shall reject all signals except those at frequency F1. METHOD 4263 19 April 1968 4263-2