Department of Defense MIL-STD-1311C — MIL-STD-1311C Test Methods for Electron Tubes – DoD Standard PDF

Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 FIGURE 4277-2. Typical plot of power versus frequency. 2.3 The average power, P, within the specified bandwidth is determined by the relationship, At Po x A P Where: A = Total area within bandwidth specified. At = Total area under plot. Po = Total average power output from TUT. 2.4 The bandwidth (BW) at a specified power density level (pdl) is obtained directly from the calibrated recorder plot as illustrated on figure 4277-2. Calibrating in this fashion the power meter reading corresponding to Y can be used without the recorder to determine the two frequencies at which Y is first reached. 2.5 Precautions. a.

The tunable filter shall have a 3 dB bandwidth that is less than 10 percent of the bandwidth being examined. b. The directional coupler shall have a relatively flat response or known calibration over the frequency range of interest and harmonics should be excluded from the thermistor. 3. Method B. Average tuning sensitivity/spot tuning sensitivity method. 3.1 In method B, power density is defined as the power per unit bandwidth delivered when the tube is tuned across the specified frequency band by a linear voltage sweep. It is, therefore, affected by both power output and tuning sensitivity variations across the band, which are allowed for in the following method.

METHOD 4277A 25 March 1970 4277-2