Downloaded from https://www.everyspec.com MIL-STD-1311C 31 January 2001 If C = 20 dB (nominal value) or greater, this simplifies to: C anti P N o ) ( 10 log 1 error negligible with MHz watts or mW F b. If P 1 is measured in dBm: MHz dBm C anti F C P N o 1 1 log 10 ) ( log 10 1 10 log If C = 20 dB(nominal) or greater, this simplifies to: error negligible with MHz dBm F C P N o ) ( log 10 1 c. If the output connections of coupler C have been interchanged because N o is small, then measure P 1 in dBm and use MHz dBm C anti F C P N o 1 1 log 10 log 10 1 10 log As before, the last term can be omitted if C 20 dB. 4. Equipment (method B).
This method may be used when the noise power in the measurement bandwidth is relatively large. The equipment required is shown on figure 4282-2. The bandwidth of the tunable bandpass filter is now the measurement bandwidth. Its stop bands must extend beyond the frequency range over which the TUT emits significant noise power. Isolators or attenuators may be required on either side of the tunable filter to improve the matching. read the power meter P 1 . The power meter may be a commercial bolometer bridge, or any method from method 4250 may be used as appropriate. 4.1 Procedure (method B).
The procedure is simply to tune the bandpass filter to each measurement frequency in turn, and 4.2 Calculation (method B). If P 1 is measured in mW (or watts): L anti P N o ) ( 10 log 1 MHz watts or mW F Where L is the insertion loss (dB) of the tunable filter, averaged over the measurement bandwidth, plus the insertion loss of any isolators or attenuators in the line. F is the bandwidth of the tunable filter at the center frequency being used. If P 1 is measured in dBm (or dBW): MHz dBW or dBm F L P N o ) ( ) ( log 10 1 METHOD 4282 4282-2 19 April 1968