4.2 Housing Щ2 To connect Device: 1. Prepare a place for mounting on the control panel (see Figure 4.4 ). 2. Install the gasket on the frame of Device to ensure degree of protection IP54. 3. Insert Device into a specially prepared hole on the front of the control panel. 4. Insert the supplied retainers into holes on the sides of Device. 5. Tighten supplied screws M4 x 35 in the holes of each retainer so that Device is firmly pressed to the front of the control panel. Demount Device in reverse order. Figure 4.3 – Panel mounting of the Device (housing Щ2) 16