Table 6.1 – Display function Table 6.2 – Assigning LEDs 30 Operating mode Displayed information Refresh rate Tachometer The current value of the pulse repetition rate obtained after filtering and averaging, taking into account scaling at the measuring input of the device ≤6 s (equal to the duration of the time interval between the leading edges of the pulses at the measuring input of the device) NOTICE If the pulse repetition rate is less than 2.5 Hz or the pulse source disappears, then the last measured value is displayed on the digital clock for 6 seconds, after which 0 will be highlighted.
If the pulse repetition rate exceeds the maximum value with a positive tolerance of 2 % (FrEQ × 1.02), then the last measured value is displayed on the display for 6 seconds, after which the value recorded in the FrEQ parameter flashes. Operating time counter Operating time 1 s Setup Parameter name and value — LED State Value Tachometer mode Operating time counter ON Measurement of operating time is in progress Ч* ON Display scale – rph Range of operating time (DDDD.HH) – from 10000 h to 9999 days 23 h М* ON Display scale – rpm Range of operating time (HHHH.MM) – from 100 h to 9999 h 59 min