Chapter 5 Setting the Printer Driver GS1-128 ❏ Specify the data of 2 to 255 digits. ❏ ‘()’ is the delimiter for the application identifiers. (printed as the HRI character, but not encoded.) ❏ The start codes (CODE A, CODE B, CODE C) and the stop code are added automatically. ❏ A symbol character FNC1, that is described after the start code, is automatically added. ❏ 2 digits of consecutive numbers must be specified as the application identifier. If it is not specified cor- rectly, an error occurs.
❏ When ‘*’ is specified, a check digit is automatically calculated, and replaced with ‘*.’ ❏ When ‘(01)’ is specified as the application identifier, the 14th digit becomes a check digit, however, it is not proved when the check digit is specified. When the 14th digit is ‘*,’ the check digit is automatically calculated, and replaced with ‘*.’ ❏ A special character is indicated by combining ‘{‘ and the next character. ❏ When the character right after ‘{‘ is not any of the following, an error occurs. 5 75 Control Character ASCII HRI Character Control Character (00h ~ 1Fh, 7Fh) Space is printed. FNC1 {1 Space is printed. FNC3 {3 Space is printed. ‘{’ {{ ‘{‘ is printed. ‘(’ {( ‘(‘ is printed.
‘)’ {) ‘)‘ is printed. ‘*’ {* ‘*‘ is printed. Left parenthesis for the application identifier ( ‘(‘ is printed. Right parenthesis for the application identifier ) ‘)‘ is printed. Check digit position * Check digit is printed.