Connecting the Power Supply Unit (PS-180) Use the PS-180 or an equivalent product as the power supply unit. Always use the PS-180 (Model: M159B/M159D) as the AC Adapter. Using a nonstandard power supply can result in electric shock or fire. Should a fault ever occur in the PS-180, immediately turn off the power to the printer and remove the power supply cable from the wall socket. WARNING Use the AC cable that meets safety standards of each country. 1 Make sure the printer is off. 2 Insert the connector of the AC cable into the inlet of the AC adapter. 3 Insert the power plug of the AC cable into the wall socket.
Be sure to remove the AC cable from the wall socket whenever connecting or dis- connecting the AC cable to the printer. Failure to do so may result in damage to the AC adapter or the printer. Make sure the wall socket power supply satisfies the rated voltage requirements of the AC adapter. Never insert the AC cable into a socket that does not meet the rated voltage requirements of the AC adapter. Doing so may result in damage to both the AC adapter and the printer. CAUTION 62 Connecting the AC Cable