Chapter 3 Handling Operating Time Settings Allows you to specify the following: The printer stops the fan and goes into sleep state when printing completes. Then, when the next printing starts, the printer starts the fan and comes out of the sleep state. For this reason, work efficiency is low when the printer is used intermittently every few seconds. In such a case, work efficiency may be improved by increasing the time settings in accordance with the way the printer is used. 3 123 Settings Description Platen Vacuum Operation Pause Time Settings Allows you to specify the time before stopping the platen vacuum fan after printing completion.
The time may be extended up to 12 hours in accordance with the way the printer is used. Fur- thermore, the printer may also be set not to go into sleep state. Data Standby Time Settings Allows you to specify the time the printer will wait for the next data to arrive after printing com- pletion. The time may be extended up to 15 seconds in accordance with the way the printer i s used.