Chapter 3 Handling Method for arranging the media • Continuous paper (Blackmark), and Die-cut label (Blackmark) Ensure a margin of 107.5 mm {4.32"} or more from the rear edge of the last ticket or label to be printed, and for labels, leave only the backing. Also, behind the last ticket or label to be printed, place a black mark [A in the figure] at the same interval up until that point [L in the figure], leave a gap of 5 ± 0.5 mm {0.20" ± 0.02} behind that, and place another black mark [B in the figure]. The maximum interval between the aforemen- tioned 2 black marks is 11 mm {0.43"}. Paper feed direction Maximum 11 mm {0.43” } L. L.
Rear edge of the last ticket black mark 5±0.5 mm {0.20±0.02” } Die-cut label (Blackmark) 107.5 mm {4.32” } or more Once the printing processing (including autocutting) for the last ticket or label is completed properly, directly after the new print data is sent to the printer, a "Media size error" occurs, and the printer stops with the print data saved. 3 • Die-cut label (Gap), and transparent die-cut label Leave only the backing for 107.5 mm {4.32"} or more after the rear edge for the last label to be printed, and do not place a label there.
Paper feed direction Rear edge of the last ticket 107.5 mm {4.32” } or more Once the printing processing (including autocutting) for the last ticket or label is completed properly, directly after the new print data is sent to the printer, a "Media size error" occurs, and the printer stops with the print data saved. 163 Paper feed direction L. L. Maximum 11 mm {0.43” } 5±0.5 mm {0.20±0.02” } Rear edge of the last ticket black mark Die-cut label (Blackmark) 107.5 mm {4.32” } or more Roll core Roll core Roll core