Composite: Turn on the check box to print the 2D symbol with a composite sym- bol. Separate the data specified to a composite symbol and a 2D symbol with “\ |” or “| \”. Describe the data in the order of the composite symbol and the 2D symbol. Example: 1234567890\ |012345678905 Use a Quiet Zone: Leaves a blank margin on the right and left side of 2D symbols for better readability. The 2D symbol printing position is moved based on the amount of margin. 2 Make settings of the following items according to the selected [ Type ]. GS1 DataBar Stacked Module: Sets the module width for GS1 DataBar Stacked. GS1 DataBar Stacked Omnidirectional Module:
Sets the module width for GS1 DataBar Stacked Omnidirectional. GS1 DataBar Expanded Stacked Module: Sets the module width for GS1 DataBar Expanded Stacked. Num Of Chars: Sets the maximum width for GS1 DataBar Expanded Stacked. The recommended values for the 2D symbols. Recommended value for setting the barcode/2D symbol font (2D symbol of stack type) * : Whether paper feed is performed during printing 2D symbol can be checked in [ Display Media Feed Position ] - [ Display Print Preview ] in the Print Preview function. For this function, see "Print Preview" on page 85 . - :
Not supported 80 Category Graphic resolution (dpi) Print Status* Minimum Module [by 360 dpi] ANSI Grade D or higher ANSI Grade C or higher ANSI Grade B or higher Plain Media 360x180 No Paper feed 6 dot - - With Paper feed 6 dot - - 360x360 No Paper feed 6 dot - - With Paper feed 6 dot - -