Ink cartridge [Input-Output] [Format] ^S(CNA, I, b [Parameter] [Function] “Ink cartridge” signal is set to the mode that is specified by parameter b. 1 Printer status: “NO INK CARTRIDGE”, “INK CARTRIDGE EMPTY”, “INK CARTRIDGE READ ERROR” 2 Printer status: “INK CARTRIDGE NEAR EMPTY” [Initial value] 0 [EX] "Ink cartridge" signal is set to the mode that is low in normal status and high in replace ink cartridge. ^XA ^S(CNA,I,E ^JUS ^XZ The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Use a USB cable or Ethernet cable to send ESC/Label commands from the host PC. For the signal output timing, see "Timing chart" on page 20 .
10 Description Definition range b = mode D/E/N/0/1/2/3/4 Parameter b Mode description D/0 “Ink cartridge” signal is not output. 1 “Ink cartridge” signal is high in normal status and low in replace ink cartridge *1. E/2 “Ink cartridge” signal is low in normal status and high in replace ink cartridge *1. 3 “Ink cartridge” signal is high in normal status and low in ink low *2 or replace ink cartridge *1. N/4 “Ink cartridge” signal is low in normal status and high in ink low *2 or replace ink cartridge *1.