Printer error [Input-Output] [Format] ^S(CNA, E, b [Parameter] [Function] “Printer error” signal is set to the mode that is specified by parameter b. “Printer error” signal shows printer's unrecoverable error, recoverable error and pause status. Printer status:
“MEDIA DETECTION ERROR”, “MEDIA SIZE ERROR”, “PAPER JAM ERR”, “NO PAPER”, “NO PAPER ERROR”, “PAPER PATH ERROR”, “PAPER REMOVAL ERROR”, “INK COVER OPEN”, “NO INK CARTRIDGE”, “INK READ ERROR”, “M/B COVER OPEN”, “NO M/B”, “M/B READ ERROR”, “REPLACE INK”, “REPLACE M/B”, “ROLL PAPER COVER OPEN”, “PAPER COVER OPEN”, “FRONT COVER OPEN”, “MEMORY FULL”, “PRINTER ERROR”, “SERVICE REQD.” [Initial value] 0 [EX] "Printer error" signal is set to the mode that is low in normal status and high in printer error. ^XA ^S(CNA,E,E ^JUS ^XZ The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Use a USB cable or Ethernet cable to send ESC/Label commands from the host PC.
For the signal output timing, see "Timing chart" on page 20 . 12 Description Definition range b = mode D/E/0/1/2 Parameter b Mode description D/0 “Printer error” signal is not output. 1 “Printer error” signal is high in normal status and low in printer error *. E/2 “Printer error” signal is low in normal status and high in printer error *.