English Inserting Cards 1. Wait until the ID LED starts flashing. 2. Insert the card straight with its read side facing the ink cartridge cover, with the bottom of the card continuously touching the card slot until it stops as shown in the picture below. ➀ ➁ 3. When the card is pulled into the printer, release it immediately. Note: When the card is pulled into the printer, a part of it comes out of the card carrier slit at the back of the printer. Be sure not to block this slit. Doing so may cause incorrect reading of data. Card carrier slit 4. When the card is ejected and ID LED flashes again, pull the card straight out of the slit. Note: Do not touch the card when it is being ejected.
Doing so may cause distortion and other problems with the image data. 16 TM-J9000/J9100 User’s Manual