CLEANING button CLEANING button POWER LED POWER LED ERROR LED INK LED (Black) ERROR LED INK LED (Color) (Unused) INK LED (Black) PAPER OUT LED PAPER OUT LED VALIDATION/ FEEDER LED VALIDATION/ FEEDER LED ID LED ID LED FEED button FEED button (TM-J9100) Two color model (TM-J9000) Single color model Figure 2-4 Control panel Table 2-1LED indicators 2-2 Setup Rev. F Name Meaning POWER LED On: Power is on. Off: Power is off. Flashing: Printer is operating (powering on, powering off, cleaning). Be sure not to turn off the printer while the POWER LED is flashing. ERROR LED On: Printer is offline. Off: Printer is online. Flashing: Printer is in error status.
See Section “4.1, When the ERROR LED is Flashing,” (page 4-1). INK LED On: ink cartridge is not installed correctly or it is time to replace the ink cartridge. (The printer goes offline, and the ERROR LED comes on.) Note: To insure print quality, some ink remain in the cartridge after the INK LED comes on. Off: Ink supply is sufficient. Flashing: Ink is low (the printer can continue printing). PAPER OUT LED On: Roll paper is nearly out (printing is possible) or out (the ERROR LED is also on). Off: Roll paper amount is enough (or roll paper disabled is selected by memory switch Msw 8-4.) VALIDATAION/FEEDER LED On: Printer processes slip paper. Off: Printer does not process slip paper.
Flashing: Printer waits for slip insertion or ejection. ID LED On: Printer processes card reading. Off: Printer does not process card reading. Flashing: Printer waits for card insertion or ejection. CLEANING button Press and hold for about 3 seconds.Then, the printer starts cleaning the print head. Note: Be sure not to use this button unless printing is faint. FEED button Press to feed roll or validation paper (when validation paper is inserted and clamped). When card, slip, or check is selected, paper is not fed.