When you install the printer horizontally, attach the control panel label as shown in the illustration below. Control panel label Note: To hang the printer on the wall, see the Wall Hanging Bracket Set Installation Manual provided with the WH-10 for instructions. When you use TM-L90 horizontally, peel off the backing sheet of the paper exit guide and attach it as shown below to prevent cut paper from falling inside the printer after paper is cut by the autocutter. CAUTION: When using the paper exit guide, do not use roll paper with a core that is smaller than the specification (inside diameter: 25.4 mm, outside diameter: 31.4 mm).
Using a smaller one may cause a paper jam at the attached paper exit guide. paper exit guide 24 Setup